CMT Srl laboratory spreads on a surface of 2,500 square metres and boasts three 10-ton overhead travelling cranes and a 6,3-ton one.
Our equipment:
Metal carpentry, set up and piping
Pantograph cutting
CMT Srl has a computerised numerical control pantograph with a cutting board with the following work sizes: 8,000x2,600 mm. It also has a nesting programme that allows the reduction of the waste of metal sheets to the minimum level.
It is possible to send the file of the pieces that you want to cut by e-mail both in .dwg and .dxf formats, or to send all the necessary details for that purpose. Contact us for any kind of inquiry.
Our laboratory
hydraulic pressbreaks with bending precision up to 15 mm
shears with a maximum cutting area of 3,000 mm and a thickness of 16 mm
calender with a maximum length of 2,500 mm and a thickness of 16 mm
two lathes, one 7-m long and electronically controlled
milling machine
slotting machine
bandsaws (cutting up to 260 mm)
radial drills
C-frame press
equipped polishing area
Among other tools, CMT Srl has a computerised numerical control pantograph with a cutting board with the following work sizes: 8,000×2,600 mm and a nesting programme. The pantograph, used also for projects for third parties, allows the cutting both with a propane torch (iron with thickness up to 80 mm), and with a plasma torch (iron + stainless steel with thickness up to 20 mm for a quite good result). It is also equipped with a mechanical marker to mark the metal sheet.
